How accurate is this wire size calculator?

Our calculator is based on NEC 2023 standards and uses the same formulas that professional electricians use. However, it provides theoretical calculations for reference only. Always consult local codes and licensed professionals for actual installations.

What's the difference between copper and aluminum wire?

Copper has better conductivity and corrosion resistance, while aluminum is lighter and less expensive. Aluminum requires special connectors (CO/ALR rated) and anti-oxidant compounds for safe installation.

What NEC articles apply to wire sizing?

Key NEC articles include: Article 310 (conductor ampacities), Article 210 (branch circuits), Article 215 (feeders), Article 430 (motors), and Article 690 (solar PV systems).

What size wire for 50A at 24V DC over 10 feet?

Use 6 AWG copper to keep voltage drop at or below 3% for a 50A load on a 24V DC circuit running 10 ft (one-way). For a tighter 2% drop (common in solar), use 4 AWG. Protect the circuit with about a 70A fuse.

24V 50A DC Wire Size at 10 Feet

Low-voltage DC wire sizing for solar, RV, marine and battery circuits — where voltage drop, not ampacity, almost always sets the wire size.

Calculations are built on the 2023 National Electrical Code (NEC) and cross-checked against the published code tables. How we verify. Last reviewed June 2026.

Copper · ≤3% drop

6 AWG

Actual drop 2.0% at 10 ft.

Copper · ≤2% drop (solar)

4 AWG

Drop 1.3%. Suggested fuse/breaker: 70A.

Drop is calculated for the full round trip (10 ft each way). At 24V even a small voltage loss is a large percentage, so voltage drop governs — the wire is larger than ampacity (8 AWG, checked at 75°C) alone would need.

Solar (NEC 690.8): PV source/output circuits base maximum current on the module short-circuit current (commonly 125% of Isc), and conductor/OCPD sizing can effectively reach 156% where a second 125% continuous factor applies. Battery, inverter and load circuits are sized differently. The 70A fuse shown is only a starting point — confirm against the module max-series-fuse, charge controller and inverter ratings.

DC safety: The fuse protects the wire — place it close to the battery/source, and never let the OCPD exceed the conductor’s ampacity, the equipment’s max fuse rating, or the PV module’s max-series-fuse. Use DC-rated breakers/fuses with an adequate interrupt rating (battery fault current can be enormous). Voltage-drop sizing does not replace ampacity, terminal/insulation temperature, bundling or ambient derating.

Voltage Drop by Wire Size (24V, 50A, 10 ft)

Wire size	Voltage drop	Within 3%?
8	3.2%	—
6	2.0%
4	1.3%
3	1.0%
2	0.8%
1	0.6%

Copper, DC resistance (NEC Chapter 9, Table 8). Aluminum is rarely used for low-voltage DC. Always also verify conductor ampacity and the manufacturer’s fuse/breaker requirement.

Common 24V DC Uses

24V solar arrays
Larger RV/marine battery banks
Off-grid inverter feeds
Telecom/industrial DC

Different current or run?

Open the calculator in DC mode pre-filled with 24V, 50A, 10 ft.

Open calculator

More DC Wire Sizes

24V 5A at 10 ft 24V 10A at 10 ft 24V 15A at 10 ft 24V 20A at 10 ft 24V 30A at 10 ft

24V 50A at 20 ft 24V 50A at 30 ft All DC sizes →DC wiring guide